DRAPERY FULLNESS DEFINED
PictureFLAT WITH TOP POCKET
All of our drapes are manufactured with a top pocket ONLY, not pre-pleated. This is the look you would have if you were to use it taut or flat. Using pocketed manufacturing verses pre-pleated drapes enables us to provide the best national rates possible. In most cases, these are 50% cheaper than our competitors.

PictureOUR DRAPE WITH 100% FULLNESS
Our rental rates and drape calculations are based on 100% fullness regardless of the fabric type.  So, if you wish to install 100 running feet, it will consist of 200ft flat even though you only pay for 100ft. This is unlike other vendors where you pay for the entire panel width; i.e. for the 200ft instead of 100ft in the example above. We charge you only for the running feet you need. Another cost you save is being charged only for the height you order, not the actual height of the panels as is typical in the industry.


PictureOPTIONAL 50% FULLNESS
At Event Drape Rental, you can control the fullness of the drape if you wish and save money.  Our rate sheet is set at 100% compression, therefore, if you want 50% compression, less panels are required. For example, if you ask for 100 running feet installed at 50% compression, it will consist of 150ft flat instead of the normal 200ft flat resulting in a lower cost.

When you rent drape from EDR this is how it will look.